Instructions for Making Cube Candles with AstorLite OK6228/1 (now IGI 4750A)

• Weigh the amount of OK6228/1 candle wax needed for your project.
• You will have to determine how much wax your Square Votive molds will hold.

• Heat OK6228/1 candle wax to between 140°F-160°F using a double-boiler system.
• Use a candle thermometer to check temperature.

• While wax is melting put clean molds in oven at 140°F or at lowest setting.

• Add up to 4-6% fragrance by melted wax weight not to exceed 1 ounce of scent to 1 pound of wax.

• Add dye until desired color is achieved.
• You can test color by dropping a few drops of wax onto a piece of white paper.

• Stir thoroughly to incorporate scent and dye.

• Remove pre-heated molds from oven.
• Pour Wax wax that is between 140° F-155° F into clean molds, the lower the temperature the less it will shrink.
• Don't forget you will need to save some wax for the 2nd pour.

• Once the candle wax has solidified about ¼ inch at bottom insert the appropriate wick.

• Allow to cool as slowly as possible.
• Do not place in a water bath or refrigerator to accelerate the cooling process.

• As the candle solidifies, re-pour wax at 20° F above initial pouring temperature.

• Trim wick as needed.

Never melt wax on a gas stove, it has a Flash Point & is Flammable.
Never leave wax unattended.

Note:  Tri-State Candlemaking Supplies shall not be held responsible for products created by you from our supplies.  You alone are responsible for product.

We strongly recommend thorough recipe testing!